Three stage battery charging (bulk, absorption, float), fully programmable
Load output with low voltage and manual disconnect (programmable)
Load output protected against over load and short circuit
Protected against reverse polarity connection of the solar panels and/or battery
Liquid crystal display For status monitoring and set-up
Load output Over-discharge of the battery can be prevented by connecting all loads to the load output. The load output will disconnect the load when the battery has been discharged to a pre-set voltage. Some loads (especially inverters) can best be connected directly to the battery, and the inverter remote control connected to the load output. A special interface cable may be needed, please see the manual. The connect and disconnect voltages are adjustable.
Day/night timing of the load output This option allows for a pre-set ON-time after dusk.
Programmable battery charge algorithm Preprogrammed algorithms for AGM, GEL, Flooded or LiFePO4 batteries (with internal BMS only)
Two 5 Volt USB outputs Maximum current (both outputs combined): 2A
