THUMPER
THUMPER REDARC DC-DC BATTERY BOX + THUMPER AGM 120AH + 8MM CIRCUIT BREAKER LOOM KIT + TRAY
THUMPER REDARC DC-DC BATTERY BOX + THUMPER AGM 120AH + 8MM CIRCUIT BREAKER LOOM KIT + TRAY
SKU:BBG-DCRD-CORE+AGM120AH+L+T
This model battery box is designed to suit all battery chemistries.
What is the difference between the CORE and the STANDARD Redarc BCDC1225? The Redarc CORE DC charger has been designed for strictly IN CABIN use! This DC charger is not designed to be mounted in locations exposed to moisture or harsh conditions. This particular battery box combination is perfect for the use INSIDE the vehicle or in a Caravan. |
Built with the Redarc BCDCN1225 DC charger |
Designed to suit new model vehicles with smart / variable alternators |
Also compatible with older model vehicles |
Will increase low voltage output from vehicle output to allow battery to reach 100% |
Will act to isolate from the vehicle's main battery once ignition has been switched off |
Designed with an independent Anderson connector for vehicle input |
Designed with an independent Anderson connector for solar panel input (regulated connection - up to 400-450watts of solar) |
Internally wired and protected with circuit breaker protection, allowing for an easy connection direct to the battery |
Equipped with multiple outlet sockets for running 12 Volt appliances |
Available in multiple packages with and without wiring looms / mounting trays and battery. |
This particular model suits a DUAL CHEMISTRY of both Lithium & AGM:
1 |
Redarc BCDC1225D 25Amp DC Battery charger (solar and vehicle compatible charge) - suitable for Lithium / Gel / AGM / Calcium |
2 | Marine grade Cigarette socket - rated to 16 Amps Includes rubber cap design to protect all sockets |
1 |
Engel Fridge type socket (2 prong design) - rated to 16 Amps |
1 | Dual USB socket - rated to 2.2Amp (min rating) - used to illuminate the Volt meter gauge and activate the USB |
2 | 50 Amp Anderson connectors - Labelled INPUT/OUTPUT (one fitted to front of box and one on rear) |
1 | 50 Amp Anderson connectors - designed purely for solar panel input - labelled "Unregulated solar input" |
1 | 50 Amp Anderson connectors - designed purely for vehicle (alternator) input - labelled "Alternator input" |
1 | All internal cabling to allow you to simply connect straight to the battery terminals |
1 | 3 year manufacturing warranty |
Length |
330 mm |
Width | 183 mm |
Height | 220 mm (Base only - Lid allows more height) |
Length |
410 mm |
Width | 260 mm |
Height | 280 mm |
Thumper Redback Extreme 120AH AGM Battery
The Redback Extreme takes the technology of an AGM battery to a whole new level! Built with heavier internal lead plates, this battery is designed for continual discharge for heavy draw appliances. Its bonded element design allows for strength against corrugated or rough terrain, making it vibration resistant and the perfect choice for an off – road battery!
Whilst the Redback Extreme is not designed as a primary cranking battery (like the Thumper Redback hybrid), it does still hold the capacity to start up to a 10Lt diesel engine. The Extreme is designed as a secondary battery rather than a primary starting battery. The perfect combination for an under bonnet dual battery system would encompass the Thumper Redback (either 100 Ah or 120 Ah) as the starter battery and the Redback Extreme (either 100 Ah or 120 Ah) as the secondary battery.
Due to design of the heavier internal plates within the Extreme battery, it allows for rapid discharge and recharge of heavy draw appliances to be continually used.
Due to the internal characteristics of the battery, the Redback Extreme will allow for longer life over that of a standard AGM battery.
- Maintenance Free
- Leak Proof
- Rapid recharge rate due to a low internal resistance
- Can reach full recharge within 2 – 3 hours from alternator
- Excellent standby use
- Excellent long term storage
- Heat resistant
- Vibration resistant due to bonded element design
- Completely sealed – can be mounted on any side
- Can be mounted in sealed compartment
- Under bonnet use
- Superior discharge ability compared to a wet cell
- High CA output
- Up to 5 times faster recharge than a wet cell battery
- Full 2 year manufacturer warranty!
Discharge Rate | Ah Capacity |
20 Hour Rate | 128 Ah |
10 Hour Rate | 120 Ah |
5 Hour Rate | 104 Ah |
1 Hour Rate | 85 Ah |
Weight | 32.5kg |
Length | 330mm |
Height | 220mm |
Width | 175mm |
Warranty | 2 Years |
The Thumper Redback has a self discharge of less than 5 % per year
(wet cell batteries discharge approx 3 – 4 % per week)
Maximum discharge current - 1250 Amp 5 seconds
Maximum charging current - 36 Amps
Float charging voltage – 13.6 – 13.8 Volts @ 25⁰C
Heavy Duty ABS case suitable for under bonnet use
The Loom
(for vehicle charge line) WITH 50 Amp Anderson fitted
1 x 50Amp Automatic reset circuit breaker
(for connection off main vehicle battery for the charge line)
1 x 50 Amp Anderson connector (Genuine)
Thumper Lithium LiFePO4 batteries
Thumper Lithium LiFePO4 batteries are fully sealed and are designed to be mounted on any angle for easy application.
Equipped with an internal battery management system (BMS), the Thumper Lithium offers safe charging and discharging with over temperature protection, under and over voltage cut off protection and also internal short circuit protection.
The LiFePO4 range of batteries are less than half the weight of a traditional AGM battery, whilst still offering all of the benefits of a heavy duty deep cycle.
These batteries are designed to hold the terminal voltage higher throughout each cycle, resulting in an increase depth of discharge and a longer overall run time with heavier draw appliances.
Features:
• Less than half the weight of a traditional lead acid battery
• Higher voltage maintained for longer run times with appliances
• Proven quality and reliability
• Compatible with chargers with an AGM or lithium setting
• For best results: Use of a lithium charger is recommended
• 3 year warranty
• Increased cycles compared to traditional lead acid
• Designed to be wired parallel
• Parallel connection is non-limited
• This battery is NOT designed for series linking
• This battery is NOT designed for starting purposes
• This battery is NOT designed for under bonnet application
Technical Specifications:
Model No. | TL-100 |
Nominal Voltage | 12.8 V |
Rated Capacity | 100 AH |
Cell Type / Chemistry | Prismatic / LiFePO4 |
Dimensions and Weight:
Length | 328 mm |
Width | 172 mm |
Height (Total) | 220 mm |
Weight | 11.2 Kg |
Operating Temperature Range:
BMS High temp cut out / Reconnect | 80˚C / 50˚C |
Discharge | -20˚C ~ 60˚C |
Charge | -20˚C ~ 45˚C |
Storage | -5˚C ~ 35˚C |
Charging Methods:
Recommended Charge Current | 10 ~ 50 Amps |
Max Charge Current | 70 Amps |
Discharge:
Max discharge current (continuous) | 100 Amps |
Peak discharge current (1-3 seconds) | 300 Amps |
BMS Current cut off | >100.5A 10s |
BMS Current cut off | >120.0A 3s |
BMS Current cut off | >150.0A 1s |
BMS Voltage cut off / Reconnect | 10.0V / 12.0V |
Self Discharge per month: | ≤3% |
Warranty | 3 years from date of purchase |
Battery Box Tray
The Tray has been designed with several mounting holes at the bottom of the tray to allow for a secure fit to the vehicle or camper trailer.
The set up comes equipped with 4 x steel 'hold down rods' and locking nuts, which perfectly secure through the side handles of the Thumper box.
As the Thumper box is designed with the 'Quick connect' lid to secure the lid to the battery base, this tray now offers a secure way to fasten your battery base to the vehicle with complete safety in mind.
This introduction to the range allows for a complete set up, which remains easy to remove if and when the need arises.
Code: | BB-TRAY |
Weight: | 686 grams |
Package Includes: | 1 x Battery Tray 4 x Steel Rods with lock nut secured already 4 x Adjustable lock nuts |
Battery Box dimensions to suit box: | L 332 x W 188mm |
MADE IN SOUTH AUSTRALIA BY BLUE APPLE THUMPER