THUMPER
THUMPER PROJECTA DC-DC LITHIUM BATTERY BOX + THUMPER 120AH LITHIUM + TRAY
THUMPER PROJECTA DC-DC LITHIUM BATTERY BOX + THUMPER 120AH LITHIUM + TRAY
SKU:BBG-DC(L)+TL-120BT+T
- Built with the Projecta IDC25L DC charger
- Designed to suit new model vehicles with smart / variable alternators
- Also compatible with older model vehicles
- Will increase low voltage output from vehicle output to allow battery to reach 100%
- Will act to isolate from the vehicle's main battery once ignition has been switched off
- Designed with an independent Anderson connector for vehicle input
- Designed with an independent Anderson connector for solar panel input (regulated connection - up to 400-450watts of solar)
- Internally wired and protected with circuit breaker protection, allowing for an easy connection direct to the battery
- Equipped with multiple outlet sockets for running 12 Volt appliances
- Available in multiple packages with and without wiring looms / mounting trays and battery.
This particular listing is for a Lithium model battery box including:
1 x Projecta IDC25L lithium model 25Amp DC Battery charger (solar and vehicle compatible charge)
2 x Marine grade Cigarette type socket - rated to 16 Amps
Includes rubber cap design to protect all sockets
1 x Engel Fridge type socket (2 prong design) - rated to 16 Amps
1 x Dual USB socket - rated to 2.5Amp (min rating)
- used to illuminate the Volt meter gauge and activate the USB
2 x 50 Amp Anderson connectors - Labelled INPUT/OUTPUT
(one fitted to front of box and one on rear)
1 x 50 Amp Anderson connectors - designed purely for solar panel input - labelled "Unregulated solar input"
1 x 50 Amp Anderson connectors - designed purely for vehicle (alternator) input - labelled "Alternator input"
- All internal cabling to allow you to simply connect straight to the battery terminals
Internal Dimensions of Battery Box
Length - 330mm
Width - 183mm
Height - 220 mm (base only - lid allows for further height)
External Dimensions of Battery Box
Length - 410mm
Width - 260mm
Height - 280mm
* Dimensions includes all protruding outlet sockets *
THUMPER LITHIUM 120AH LiFePO4 BATTERY
Thumper Lithium LiFePO4 batteries are fully sealed and are designed to be mounted on any angle for easy application.
Equipped with an internal battery management system (BMS), the Thumper Lithium offers safe charging and discharging with over temperature protection, under and over voltage cut off protection and also internal short circuit protection.
The LiFePO4 range of batteries are less than half the weight of a traditional AGM battery, whilst still offering all of the benefits of a heavy duty deep cycle.
These batteries are designed to hold the terminal voltage higher throughout each cycle, resulting in an increase depth of discharge and a longer overall run time with heavier draw appliances.
These batteries are quality! Check out the internal BMS on this battery compared to cheaper brands
Features:
• Less than half the weight of a traditional lead acid battery
• Higher voltage maintained for longer run times with appliances
• Proven quality and reliability
• Compatible with chargers with an AGM or lithium setting
• For best results: Use of a lithium charger is recommended
• 3 year warranty
• Increased cycles compared to traditional lead acid
• Designed to be wired as parallel OR series
• Parallel connection is non-limited
• Max series voltage is 48 Volt (max 4 series)
• This battery is NOT designed for starting purposes
• This battery is NOT designed for under bonnet application
Technical Specifications:
Model No. | TL-120P |
Nominal Voltage | 12.8 V |
Rated Capacity | 120 AH |
Cell Type / Chemistry | Prismatic / LiFePO4 |
Dimensions and Weight:
Length | 328 mm |
Width | 172 mm |
Height (Total) | 220 mm |
Weight | 13.8 Kg |
Operating Temperature Range:
BMS High temp cut out / Reconnect | 80˚C / 50˚C |
Discharge | -20˚C ~ 60˚C |
Charge | -20˚C ~ 45˚C |
Storage | -5˚C ~ 35˚C |
Charging Methods:
Recommended Charge Current | 10 ~ 50 Amps |
Max Charge Current | 80 Amps |
Discharge:
Max discharge current (continuous) | 100 Amps |
Peak discharge current (1-3 seconds) | 300 Amps |
BMS Current cut off | >100.5A 10s |
BMS Current cut off | >120.0A 3s |
BMS Current cut off | >150.0A 1s |
BMS Voltage cut off / Reconnect | 10.0V / 12.0V |
Self Discharge per month: | ≤3% |
Warranty | 5 years from date of purchase | as of June 2023 |
THUMPER BATTERY BOX TRAY
The Tray has been designed with several mounting holes at the bottom of the tray to allow for a secure fit to the vehicle or camper trailer.
The set up comes equipped with 4 x steel 'hold down rods' and locking nuts, which perfectly secure through the side handles of the Thumper box.
As the Thumper box is designed with the 'Quick connect' lid to secure the lid to the battery base, this tray now offers a secure way to fasten your battery base to the vehicle with complete safety in mind.
This introduction to the range allows for a complete set up, which remains easy to remove if and when the need arises.
Designed by Blue Apple Thumper for the Thumper battery boxes.
Weight: | 686 grams |
Package Includes: | 1 x Battery Tray 4 x Steel Rods with lock nut secured already 4 x Adjustable lock nuts |
Battery Box dimensions to suit box: |
L 332 x W 188mm |